How: System Requirements Hazard Analysis With Mil-Std-882E

What you’ll learn
Recognize the Elements of System Requirements Hazard Analysis
Understand Task 203’s Purpose and Vital Importance
Understand Task 203’s Description; Reporting & Contracting Requirements
Apply Lessons Learned to Enhance Task 203’s Value and Effectiveness

Requirements
No prior experience needed, although you will benefit from understanding basic concepts of System Safety.

Description
System Requirements Hazard AnalysisWe’re talking about system requirements hazard analysis, as part of our series on Mil-Std-882E. It’s a very widely used system safety engineering standard and its influence is found in many places, not just on military procurement programs.Topics for this SessionWe’re going to look at this task, which is very important, possibly the most important task of all, as we’ll see. We’ll talk about the purpose of the task, which is word for word from the task description itself. We’re going to talk about in the task description, the three aims of this task, which are to determine or work out requirements, incorporate them, and then assess the compliance of the system with those requirements, because, of course, it may not be a simple read-across. We’ve got six slides on that. That’s most of the task. Then we’ve just got one slide on contracting, which if you’ve seen any of the others in this series, will seem very familiar. We’ve got a little bit of a chat about Section 4.2 from the standard and some commentary, and the reason for that will become clear. So, let’s crack on.System Requirements Hazard Analysis: PurposeTask 203.1, the purpose of Task 203 is to perform and document a System Requirements Hazard Analysis or SRHA. And as we’ve already said, this aims to determine the design requirements. We’re going to focus on design rather than buying stuff off the shelf – we’ll talk about the implications of that a little bit later. Design requirements to eliminate or reduce hazards and risks, incorporate those requirements, into a says, into the documentation, but what it should say is incorporate risk reduction measures into the system itself and then document it. And then finally, to assess compliance of the system with these requirements. Then it says the SRHA address addresses all life-cycle phases, so not just meant for you to think about certain phases of the program. What are the requirements for the system throughout life? And in all modes. Whether it’s in operation, whether it’s in maintenance or refit, whether it’s being repaired or disposed of, whatever it might be.

Overview
Section 1: Introduction

Lecture 1 Course Introduction

Section 2: Course Videos

Lecture 2 System Requirements Hazard Analysis (Task 203)

Section 3: Free Preview of the Next Three Courses in the Series

Lecture 3 Sub System Hazard Analysis with Mil-Std-882E

Lecture 4 System Hazard Analysis with Mil-Std-882E

Lecture 5 Operating & Support Hazard Analysis (Task 206) with Mil-Std-882E

Section 4: Get a Free Preview of the Next Courses in the Series

Lecture 6 Sub System Hazard Analysis (Task 204)

Lecture 7 System Hazard Analysis (Task 205)

Lecture 8 Operating & Support Hazard Analysis (Task 206)

Beginners in Hazard Analysis, Safety Risk Assessment, Designers, Managers.