Siemens Sinamics S120 Service and Commissioning

Siemens Sinamics S120 Service And Commissioning Course by Caner Sezer

What you’ll learn:
Fundamentals and overview
STARTER project structure
Control Units and additional system components
STARTER connection to target device
Booksize power units
Control word, setpoint and device trace
Topology
Chassis power units and Cabinet modules
Closed-loop control structure, servo mode
Closed-loop control structure, vector mode
Setpoint channel
Diagnostics
Basic positioner
Drive-based safety functions
Communication
Further drive functions
Support and training
Exercises
Comments And Notes
Recommendation

Requirements
Basic Knowledge of Siemens Product Family
Required Siemens Programs to be Installed
Basic Knowledge of Drives / Frequency Converters

Description
Hello everyone,

With this course from one collegue to another about Sinamics both Hardware And Software Side you will able to get information and for your future you will gain more experience during your business life. So from this point of view if you are interested with industrial automation sector, specially motion control area, Sinamics is one of the most commonly used product in industry.

From beginning step by step this course offers you complete walktrough. You will become familiar with the fundemental principle of a frequency converter, concenpt of modular sinamics s120 system, basic operating procedures of starter. You will become familiar with the other components of the sinamics s120 drive system such as Single axis devices, chassis units, cabinet modules, sensors and terminal modules, principle of line infeed operation : BLM, SLM, ALM, interconnect signals using the BICO technology.

You will know the rules of the drive-cliq topology, able to identify the firmware version of the components, know the differences between the set and actual topology, familiar with the rules for replacing modules. You will be familiar with the servo and vector operating modes, the operating principles of speed current and torque control, design of an induction motor, optimize the induction motor with stationary and turning measurement, signal characteristics in the speed setpoint channel.

You will become familiar with the various options for specifying the speed setpoint and how to influence it. You will be able to parameterize fixed setpoints, the motor potentiometer and the ramp-function generator.

You will be able to use the LEDs and the status display of the BOP20, work with fault memory and alarm history, change fault rections and trigger to faults, basics of closed-loop position control. You will be able to traverse the axis with a traversing program, parameterize and test the safety functions.

You will know the fundamental principle of data transfer between converter and Simatic S7, set up communications via Profibus on the basis of a standart telegram. You will become familiar with essential converter functions such as DC link voltage limiting and kinetic buffering, DCC programming language.

I hope you will enjoy this course.

With sincerely.

Caner Sezer.

Who this course is for
Target students are electrical electronic engineering with bach. deg.
Computer Programmers
Beginner of PLC software developers
University students doing practice with project or lab